A two part epoxy ideal for joining aluminum parts.

• Anodized aluminum curved washers.
• Bright dip anodized to a marine grade standard.
• Machined to fit the outside diameter of 1 1/2" Schd. 40 aluminum pipe
• Center hole measures 3/8"
• Allows you to create a flat surface on pipe that accessories can be bolted to.
• SOLD IN SETS OF (4).

• Anodized aluminum bolt on sway tab or lifting pad.
• SOLD IN PAIRS.

Anodized Aluminum End Caps Fit 1 1/2 Schd.40 Aluminum Pipe (Outside Diameter 1.90").

• Aluminum Clevis Pin for 1 1/2" schedule 40 pipe which measures 1.90" O.D.
• May be installed with two part epoxy and stainless steel set screws or welded into place.
• SOLD IN PAIRS.

• An 8" anodized aluminum sleeve for 1 1/2" schedule 40 pipe.
• Comes pre-drilled with fasteners.
• Inner Diameter of sleeve measures 1.9"
• SOLD IN PAIRS.

• Our Standard Tower Mount Fitting, designed over 27 years ago.
• Can be used to mount just about any structure from a small fishing arch to a large tuna tower.
• Machined from 6061 T6 aluminum.
• Bright dip anodized to a marine grade standard.
• Mounting pad is 3 1/2” in diameter with five countersunk mounting holes for 1/4-20 oval or flat head mounting bolts.
• Matching back up plate is 3 1/2” in diameter and pre-drilled for the mounting bolts.
• Pin connector fits into 1 1/2” Schd. 40 pipe and is secured in mounting pad with a 3/8” stainless hex bolt.
• Nylon washers between female mounting pad and male pin eliminate metal to metal contact which can cause oxide staining and noise.
• Fittings may be installed with two part epoxy and stainless steel set screws or welded in place.
• KIT CONTAINS TWO COMPLETE ASSEMBLIES.

• Special tower mount pad fitting with a base only 2” in diameter.
• Machined from solid 6061 T6 billet.
• Pin sized for 1 1/2” Schd 40 pipe (1.90” o.d. – 1.61” i.d.).
• Pin may be permanently installed in pipe with 2 part epoxy and stainless set screws or welded in place.
• Fitting can be used where there is insufficient mounting area for our standard base.
• Bright dip anodized to a marine grade standard.
• Mounting base is 2” in diameter and has two countersunk mounting holes for 1/4-20 oval or flat head mounting bolts. Matching back up plate is 3 1/2” in diameter and is pre-drilled for the mounting bolts.
• Backing plates may be trimmed to fit into a smaller area if required.
• Pin secured to the mounting pad with a 3/8” stainless allen bolt.
• Nylon washers between female mounting pad and male pin eliminate metal to metal which can cause oxide staining and noise.

• Accepts 1 ½” schedule 40 pipe (1.90” outside diameter).
• May be used as leg bases for towers, benchs, or tables.
• Ends may be opened and used with 1 ½” schedule 40 pipe to make a wire chase.
• SOLD IN PAIRS.

• Arch hinge system kit allows your arch to be folded for increased clearance.
• Normally installed to allow the arch to fold aft into the cockpit area.
• Hinge System replaces the standard “Pin & Pad” mounting hardware, with hinge hardware and fairing pads for the aft legs.
• Included in kit are quick release pins for securing the forwards legs.