Home > Tower Parts > Tower Parts >

Side Mount Fitting for Hinge System
Specialty Side Mount Fitting


 
Alternative Views:


Price: $160.00 /Pr.



Product Code: KIT02200
Qty:

Description
 
  • Specialty tower mount fitting.
  • Allows for side mounting of Tower structure with the possibility of folding or quick removal when fitted with Q.R. pins. Tower Pin fits 1 1/2” Schd 40 pipe (1.90” o.d. – 1.61” i.d.)
  • May be permanently installed in pipe with 2 part epoxy and stainless set screws, or may be welded in place.
  • Fitting designed for those unusual mounting situations where a typical base will not allow folding or removal.
  • Machined from solid billet 6061 T6 aluminum.
  • Bright dip anodized to a marine grade standard.
  • Mounting base is 2” in diameter with three countersunk mounting holes for 1/4-20 oval or flat head mounting bolts.
  • Comes with patented counter rotating circular Delrin wedges to space fitting off the fiberglass surface and allow adjustment to angled or cambered surfaces.
  • Matching back up plate is 3 1/2” in diameter pre-drilled for the mounting bolts.
  • Backing plates can be trimmed to fit into a smaller area if required.
  • Pin connector fits into 1 1/2” Schd. 40 pipe and is secured to mounting pad with a 3/8” stainless allen bolt.
  • Nylon washers between female mounting pad male pin eliminate metal to metal contact which can cause oxide staining and noise.

Share your knowledge of this product. Be the first to write a review »