CALL US TOLL FREE
Tower Parts & Accessories
2" Diameter Tower Mount Fitting Kit for 1 1/2" Schd. 40 Pipe
Special tower mount pad fitting with a base only 2” in diameter.
Machined from solid 6061 T6 billet.
Pin sized for 1 1/2” Schd 40 pipe (1.90” o.d. – 1.61” i.d.).
Pin may be permanently installed in pipe with 2 part epoxy and stainless set screws or welded in place.
Fitting can be used where there is insufficient mounting area for our standard base.
Bright dip anodized to a marine grade standard.
Mounting base is 2” in diameter and has two countersunk mounting holes for 1/4-20 oval or flat head mounting bolts. Matching back up plate is 3 1/2” in diameter and is pre-drilled for the mounting bolts.
Backing plates may be trimmed to fit into a smaller area if required.
Pin secured to the mounting pad with a 3/8” stainless allen bolt.
Nylon washers between female mounting pad and male pin eliminate metal to metal which can cause oxide staining and noise.
2" Diameter Tower Mount Fitting Kit for 1" Schd. 40 Pipe
Sunbrella Replacement Fabic for Atlantic Towers Walkaround Tee Top
Sunbrella Replacement Fabic for Atlantic Towers Standard Trampoline T-Top - White (TTS57000)
Standard Stand Off Kit
Sunbrella Replacement Fabic for Atlantic Towers Super Trampoline T-Top - Blue (TTS79000)
Angle Tie Down Pads
Sunbrella Replacement Fabic for Atlantic Towers Standard Trampoline T-Top - Black (TTS56000)
Share your knowledge of this product.
Be the first to write a review »
Terms & Conditions
JOIN OUR EMAIL LIST
Return to Atlantic Towers