CALL US TOLL FREE
Tower Parts & Accessories
Pair of Tower Mount Fittings for 1" Schd. 40 Pipe
Our Standard Tower Mount Fitting, designed over 27 years ago.
Can be used to mount just about any structure from a small fishing arch to a large tuna tower.
Machined from 6061 T6 aluminum.
Bright dip anodized to a marine grade standard.
Mounting pad is 3 1/2” in diameter with five countersunk mounting holes for 1/4-20 oval or flat head mounting bolts.
Matching back up plate is 3 1/2” in diameter and pre-drilled for the mounting bolts.
Pin connector fits into 1" Schd. 40 pipe and is secured in mounting pad with a 3/8” stainless hex bolt.
Nylon washers between female mounting pad and male pin eliminate metal to metal contact which can cause oxide staining and noise.
Fittings may be installed with two part epoxy and stainless steel set screws or welded in place.
KIT CONTAINS TWO COMPLETE ASSEMBLIES.
Angle Tie Down Pads
2" Diameter Tower Mount Fitting Kit for 1 1/2" Schd. 40 Pipe
Sunbrella Replacement Fabic for Atlantic Towers Super Trampoline T-Top - Navy (TTS79500)
Clevis Pin for 1 1/2" Schd. 40
Standard Stand Off Kit
Marine Tex Two Part Epoxy
Wire Hole Covers
84" Length of 1 1/2" Schd. 40 Anodized Aluminum Pipe
Share your knowledge of this product.
Be the first to write a review »
Terms & Conditions
JOIN OUR EMAIL LIST
Return to Atlantic Towers